Retrofit Control Unit For Illuminated Door Sill Moldings With Mercedes-Benz Lettering - AZ82.20-P-0005-05LC
Model 217.3/4
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1084-02A | Binder Duotec® Pilz in Pilz Klett - with adhesive 32 | Klettband Technik Schultz UG Schulstrasse 6 71111 Waldenbuch Germany Tel.: +49 (0) 7157 6754-83 or 82 Fax: +49 (0) 7157 6696815 info@klettband-technik.de http://www.klettband-technik.de |
- Stick felt tape (6) to upper side of illuminated door sill molding control unit (1).
- Stick Velcro strip (7) to underside of illuminated door sill molding control unit (1).
- Remove carrier foils from Velcro strips of illuminated door sill molding control unit (1).
- Glue illuminated door sill molding control unit (1) onto powertrain control unit.
The illuminated door sill molding control unit (1) must not obstruct installation of the footrest.