LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> S560 4Matic >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Electrical System - Body - 217 Chassis (3 Of 7) >> Testing & Repair >> Remove/Install Outer Fan Motor Of Front Headlamp Unit - AR82.10-P-4743LFM

Remove/Install Outer Fan Motor Of Front Headlamp Unit - AR82.10-P-4743LFM

Model 217 

Model 222 

up to model year 2018 

with code 640 (SAE dynamic LED headlamps, right-hand traffic) 

Model 222 

up to model year 2018 

with code 641 (Dynamic LED headlamps, left-hand traffic) 

Model 222 

up to model year 2018 

with code 642 (Dynamic LED headlamps, right-hand traffic) 

Model 222 

with code 631 (Static LED headlamps, left-hand traffic) 

Model 222 

with code 632 (Headlamps, LED, static, right-side traffic) 

Fig 1: Front Headlamp Outer Fan Motor Component Location - Model 217 Up To Model Year 2018
G15346739Courtesy of MERCEDES-BENZ USA

Shown on left front lamp unit (E1) up to model year 2018 

CAUTION Risk of injury  caused by burns to skin and eyes, risk of poisoning caused by inhaling vapors when working with plastics Wear protective gloves and safety glasses.
Ensure that the work area is adequately ventilated.
AS00.00-Z-0001-02A
Topical note  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVING Remove     
1 Remove left front lamp unit (E1) or right front lamp unit (E2) Model 217 AR82.10-P-4730LC 
    Model 222 AR82.10-P-4730LF
2.1 Cut open housing of left front lamp unit (E1) or right front lamp unit (E2) inside web (1), along notch, using a hot knife If no cap (5) is fitted.  
REFER TO SPECIAL TOOLS 000 588 03 84 00 Hot knife NOTES Do not damage the web (1).
Otherwise the housing will not be leaktight.
WS82.00-P-0026B
    NOTES Carefully cut open the housing.
Otherwise, the component parts in the housing will be damaged.
 
2.2 Remove screws (4) and cap (5) If the cap (5) is fitted.  
3 Release and disconnect electrical connector (2)    
4 Loosen mounting clamp (3) and remove left front lamp unit fan motor 1 (E1m4) or right front lamp unit fan motor 1 (E2m4), as applicable    
INSTALLING Install     
5 Insert left front lamp unit fan motor 1 (E1m4) or right front lamp unit fan motor 1 (E2m4) and secure with mounting clamp (3)    
6 Put together electrical connection (2) until it is locked    
7 Position cap (5) on web (1) and tighten with screws (4)    
8 Install left front lamp unit (E1) or right front lamp unit (E2) respectively Model 222 AR82.10-P-4730LF
    Model 217 AR82.10-P-4730LC