Remove/Install Eyeglass Compartment On Roof - AR68.30-P-4400LF

Model 217.3, 222 

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove
1	Remove overhead control panel control unit (1)		AR82.20-P-1000LF
2	Open eyeglasses compartment (2)
3	Push eyeglasses compartment (2) to side and unclip at opposite side
4	Unclip damper (5) from inside toward outside
	Install
5	Insert spring clips (3) on eyeglasses compartment (2) into present groove
6	Insert eyeglasses compartment (2) at one side and clip in on opposite side	Position eyeglasses compartment (2) vertically so that spring clips (3) are positioned on front of retaining pins (4).
7	Check whether spring clips (3) are seated correctly after installing eyeglasses compartment (2)	The spring clips (3) should be seated in front of the retaining pins (4). Otherwise the eyeglasses compartment (2) cannot be opened. In the case of complaints. ↓ Press spring clips (3) toward front of retaining pins (4) using screwdriver.
8	Close eyeglasses compartment (2)
9	Clip in damper (5) from outside toward inside
10	Install overhead control panel control unit (1)		AR82.20-P-1000LF
	Check
11	Check glasses compartment (2) for proper operation by opening and closing	Perform test procedure at least three times.