Remove/Install Rear Stabilizer Bar Linkage - AR32.35-P-3329S

Model 223 

except code 490 (Electrohydraulic suspension) 

Shown on model 223 with code 201 (Rear axle steering) 

Fig 1: Rear Stabilizer Bar Linkage Components Location - Model 223 Except Code 490

Courtesy of MERCEDES-BENZ USA

Notice	Notes on handling, transport and storage of ceramic brake disks		AH42.10-P-9406-13A
Notice	Notes on handling, transport and storage of composite brake disks		AH42.10-P-9406-12LF
Notice	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Remove corresponding rear wheel.		AR40.10-P-1102A
2	Remove torsion bar linkage (2) from stabilizer (1).	Model 223 except code 201 (Rear axle steering) except code 216 (Rear axle steering) except code 490 (Electrohydraulic suspension) except code Z07 (B7 armoring on special protection version) Model 223 with code 201 (Rear axle steering) with code 216 (Rear axle steering) except code 490 (Electrohydraulic suspension) Model 223 with code Z07 (B7 armoring on special protection version) except code 490 (Electrohydraulic suspension) Screw/Nut, torsion bar linkage to torsion bar	*BA32.20-P-1002-04V
3	Remove torsion bar linkage (2) from wheel carrier (3).	Model 223 except code 201 (Rear axle steering) except code 216 (Rear axle steering) except code 490 (Electrohydraulic suspension) except code Z07 (B7 armoring on special protection version) Model 223 with code 201 (Rear axle steering) with code 216 (Rear axle steering) except code 490 (Electrohydraulic suspension) Model 223 with code Z07 (B7 armoring on special protection version) except code 490 (Electrohydraulic suspension) Screw/Nut, torsion bar linkage to wheel carrier	*BA32.20-P-1003-04V
4	Remove torsion bar linkage (2).
	Check
5	Check torsion bar linkage (2) for damage and wear.	If torsion bar linkage (2) is reused. If there is a problem, ↓ replace torsion bar linkage (2).
6	Install in the reverse order.