Remove/Install Fuse And Relay Module For Engine Compartment - AR54.15-P-0005S
Model 223
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Detach ground line of on-board electrical system battery. | AR54.10-P-0051S | |
| 2 | Remove cover in engine compartment on driver's side. | ||
| 3 | Remove wiper arm. | AR82.30-P-6100S | |
| 4 | Remove water drain (1). | ||
| 5 | Remove wiring harness (2) from struts (3, 4). | ||
| 6 | Remove struts (3, 4). | *BA62.30-P-1009-02P | |
| *BA62.30-P-1008-02P | |||
| *BA62.30-P-1007-02P | |||
| *BA62.30-P-1002-02P | |||
| 7 | Unclip retaining clip (5) from cap (7). | ||
| 8 | Unscrew screws (6) and remove cap (7) from fuse and relay module (F152/3). | ||
| 9 | Release fuse and relay module (F152/3) (arrows) and remove from housing. | ||
| 10 | Remove positive line (9) from fuse and relay module (F152/3). | *BA54.15-P-1005-01J | |
| 11 | Disconnect electrical connectors from fuse and relay module (F152/3). | ||
| 12 | Remove relay holders (8) from fuse and relay module (F152/3). | ||
| 13 | Remove fuse and relay module (F152/3). | ||
| 14 | Install in the reverse order. |
FUSE AND RELAY BOX
| Number | Designation | Model 223 | ||
|---|---|---|---|---|
| BA54.15-P-1005-01J | Nut, positive terminal to engine fuse and relay module | M8 | Nm | 16 |
FRONT AREA WITH FRONT REINFORCEMENT
| Number | Designation | Model 223 | |
|---|---|---|---|
| BA62.30-P-1002-02P | Screw, upper/lower struts to firewall | Nm | 30 |
FRONT AREA WITH FRONT REINFORCEMENT
| Number | Designation | Model 223 | |
|---|---|---|---|
| BA62.30-P-1007-02P | Screw, upper strut on suspension strut tower mounting console | Nm | 30 |
FRONT AREA WITH FRONT REINFORCEMENT
| Number | Designation | Model 223 | |||
|---|---|---|---|---|---|
| BA62.30-P-1008-02P | Screw, center/lower strut to suspension strut tower mounting console | Stage 1 | Nm | 35 | |
| Stage 2 | Nm | 50 | |||
| Stage 3 | Loosen | ∠° | 180 | ||
| Stage 4 | Nm | 50 | |||
FRONT AREA WITH FRONT REINFORCEMENT
| Number | Designation | Model 223 | |
|---|---|---|---|
| BA62.30-P-1009-02P | Screw, center strut to longitudinal member mounting console | Nm | 30 |