Side Wall Reinforcement Partially Prepare For Installation - Ar63.20-P-0861-03S

Model 223.0/1/9 

The following operation steps are shown on model 223.1 on the left side of the vehicle and must be similarly performed on the right side of the vehicle in the event of damage.

The superordinate service document as well as the safety information in the service document must be observed.

1. Grind mating surface at side wall reinforcement (1) down to bare metal in cross-hatched area.

   Observe preliminary treatment of bonding surface.

2. Remove grinding dust.

   Courtesy of MERCEDES-BENZ USA