Remove/Install Trim On Battery Of 12 V On-Board Electrical System In Trunk - AR54.10-P-0051-02SG

Model 223 with engine 279 

with code Z07 (B7 armoring on special protection version) 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A

Fig 1: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA

1. Open trunk lid.
2. Remove protective bag (1).
3. Release quick-release fasteners (2.1) at top of trim (2).
4. Fold trim (2) at top towards rear.
5. Remove trim (2).

   Insert trim (2) at bottom into cutouts in load compartment floor (3).

6. Remove pins from holders (3.1).
7. Remove holders (3.1) using disassembly tool .
8. Lift up load compartment floor (3) and remove.
9. Install in the reverse order.

   Courtesy of MERCEDES-BENZ USA