Remove/Install Pump For LiDAR Cleaning System - AR54.71-P-0009S
Model 223
with code 200 (Conditionally automated driving)
| Risk of fire and explosion caused by ignition of window washing fluid or antifreeze and their vapors. Risk of poisoning caused by swallowing window washing fluid or antifreeze or inhaling their vapors. Risk of injury or physical irritations caused by contact of window washing fluid or antifreeze with eyes, mucous membranes or skin. | Wear protective clothing and tight-fitting safety glasses. No open flames, fire or ignition sources. Avoid contact with eyes, mucous membranes and skin. When working with window washing fluids or antifreeze, do not eat, drink, or smoke. Do not inhale vapors and ensure sufficient ventilation in the working area. Store window washing fluid and antifreeze leakfree in safely closed original containers and out of the reach of children. | AS82.35-Z-0001-01A | |
| Remove/install | |||
| 1 | Remove left front wheel. | AR40.10-P-1102A | |
| 2 | Remove rear section of left fender liner. | Model 223 with code 200 (Conditionally automated driving) |
|
| Model 223.0/1 with code 200 (Conditionally automated driving) |
AR88.10-P-1301S | ||
| 3 | Disconnect electrical connector (1) from LiDAR cleaning system pump (M5/10). | ||
| 4 | Remove line (2) from LiDAR cleaning system pump (M5/10). | ||
| 5 | Remove LiDAR cleaning system pump (M5/10). | ||
| Check | |||
| 6 | Check seal of LiDAR cleaning system pump (M5/10). | If there is a problem, ↓ install new gasket. |
|
| 7 | Install in the reverse order. |