Remove/Install Moisture Sensor - AR54.71-P-0004S

Model 223 

with code 200 (Conditionally automated driving) 

Courtesy of MERCEDES-BENZ USA

Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Remove rear section of fender liner (2) at front left.	Model 223 with code 200 (Conditionally automated driving)
		Model 223.0/1 with code 200 (Conditionally automated driving)	AR88.10-P-1301S
2	Remove bolts (1).
3	Disconnect electrical connector from moisture sensor (B165).
4	Unclip moisture sensor (B165) from holder (3).	Ensure that moisture sensor (B165) is seated correctly in holder (3) (arrows).
5	Install in the reverse order.