Remove/Install Interior Compartment Pre-Fuse Box - AR54.15-P-1350S

Model 223 

Fig 1: Interior Compartment Pre-Fuse Box Components Location - Model 223 (Shown Except Code ME10)

Courtesy of MERCEDES-BENZ USA

Shown except code ME10 (Hybrid vehicle) 

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Move front passenger seat fully backward.
2	Detach ground line of on-board electrical system battery.		AR54.10-P-0051S
3	Remove floor mat in front passenger footwell.
4	Remove caps (1) from floor covering (2) in front passenger footwell.
5	Fold back floor covering (2) in front passenger footwell toward rear.
6	Remove nuts (3) and remove footrest (4).
7	Remove electric lines (5) from pre-fuse box (F150/2).	The number of electric lines (5) varies depending on the vehicle equipment. The connections of the electric lines (5) are shape-coded.
		Nut, positive terminal to vehicle interior pre-fuse box	*BA54.15-P-1003-01J
8	Release and disconnect electrical connector (6).	Model 223 except code ME10 (Hybrid vehicle)
9	Unclip pre-fuse box (F150/2) from holder (7) (arrows) and remove.
10	Install in the reverse order.

FUSE AND RELAY BOX

Number	Designation			Model 223
BA54.15-P-1003-01J	Nut, positive terminal to vehicle interior pre-fuse box	M6	Nm	8
		M8	Nm	16