Wiring Diagram For Signal Acquisition And Actuation Module (SAM) Control Unit - PE54.21-S-2127-97VVH
Model 447.6 except Code M8E (Electric motor 85 kW/battery 60 kWh (usable)) except Code ME0 (Electric motor 85 kW) except Code XM0 (Facelift) except Code XM7 (MOPF II) except Code ZL3 (National version for Latin America) ConnectorB3
Model 447.7 except Code M7E (Electric motor 150 kW/battery 60 kWh (usable)) except Code ME0 (Electric motor 85 kW) except Code ME4 (Electric motor 145 kW) except Code XM0 (Facelift) except Code XM7 (MOPF II) except Code ZL3 (National version for Latin America) ConnectorB3
| Code : | Designation: | Position: |
|---|---|---|
| AO | Color Code key | 72L |
| Code E36 | Additional battery cutoff relay | 57D |
| Code EK1 | Terminal strip for electrical connection | 52D |
| Code FY2 | Additional door lock | 10E |
| Code FY2 | Additional door lock | 6E |
| Code G42 | 7G-TRONIC PLUS automatic transmission | 44D |
| Code L84 | Additional rear turn signal lamps on roof | 48D |
| Code MJ8 | ECO start/stop function | 37D |
| Code MJ8 | ECO start/stop function | 44D |
| Code MJ8 | ECO start/stop function | 24D |
| Code MJ8 | ECO start/stop function | 28D |
| Code MJ8 | ECO start/stop function | 32D |
| Code W32 | Rear passenger compartment electr. pop-out window | 13D |
| Code W50 | Rear-end door, two-leaf, 180 degrees without window | 2D |
| Code W54 | Rear-end doors, two-leaf, opening as far as side wall | 2D |
| Code W65 | Liftgate | 10E |
| Code ZH6 | Marco Polo ACTIVITY | 57D |
| F109 | Emergency-P battery or backup battery fuse | 46L |
| K120 | On-board electrical system backup battery relay | 38L |
| K40/12 | Fuse and relay module, front passenger footwell | 54L |
| K57 | Battery cutoff relay | 59L |
| M14/12 | Rear-end door operation central locking motor | 3L |
| N10/1 | Signal acquisition and actuation module (SAM) control unit | 28A |
| N10/1 | Signal acquisition and actuation module (SAM) control unit | 60A |
| N10/1 | Signal acquisition and actuation module (SAM) control unit | 68A |
| N10/1 | Signal acquisition and actuation module (SAM) control unit | 12A |
| N10/1 | Signal acquisition and actuation module (SAM) control unit | 20A |
| N10/1 | Signal acquisition and actuation module (SAM) control unit | 36A |
| N10/1 | Signal acquisition and actuation module (SAM) control unit | 44A |
| N10/1 | Signal acquisition and actuation module (SAM) control unit | 52A |
| N3/33 | CDI control unit | 26L |
| N3/34 | ME-SFI [ME] control unit | 34L |
| N3/36 | CDI control unit | 30L |
| N9/1 | Additional turn signal module control unit | 50L |
| U12 | Valid for left-hand drive vehicles | 49E |
| U13 | Valid for right-hand drive vehicles | 50E |
| U13 | Valid for right-hand drive vehicles | 6D |
| U13 | Valid for right-hand drive vehicles | 10E |
| U130 | Valid without Code T19 Left sliding door | 10D |
| U142 | Valid without Code T55 Electric operation for right sliding door | 10D |
| U142 | Valid without Code T55 Electric operation for right sliding door | 6D |
| U143 | Valid without Code T56 Electric operation for left sliding door | 10D |
| U143 | Valid without Code T56 Electric operation for left sliding door | 6D |
| V19 | ECO start/stop function diode | 42L |
| W43/2 | Right vehicle interior firewall ground point | 42G |
| X225 | Main wiring harness/firewall main wiring harness 1 electrical connector | 51G |
| X8/63 | Right rear-end door electrical connector 1 | 3H |
| Z82/7 | Open sliding door double lock central locking connector sleeve | 7F |
| Z82/8 | Close sliding door double lock central locking connector sleeve | 8F |