Caravan Control Unit Parameters Of Analog Outputs, Function - GF54.21-D-5026TSA

Model 447 

with code JA3 (Intelligent body control.) 

with code XM7 (MOPF II) 

Model 907, 910 

with code JA3 (Intelligent body control.) 

General 

Analog outputs are used to set voltage values to, for example, control a device that executes corresponding actions depending on the voltage applied to its input.

The MB Advanced Control, control unit (N175) can operate 5 analog outputs.

Parameters, analog outputs 

The analog outputs can switch a maximum of 10 V and a minimum of 250 mV.

The analog outputs have a resolution of 100 mV and a tolerance of 200 mV.

The analog outputs can supply a maximum of 2 mA.

The load on the analog outputs must be greater than 5 kOhm.

As soon as the read voltage value does not match the output voltage, the

MBAC switches off the analog output and creates an internal fault entry.

	Caravan control unit configuration of analog outputs, function		GF54.21-D-5021TSA
	Caravan control unit configuration of analog inputs, function		GF54.21-D-5022TSA
	Caravan control unit configuration of digital outputs, function		GF54.21-D-5023TSA
	Caravan control unit configuration of digital inputs, function		GF54.21-D-5024TSA
	Caravan control unit parameters of analog inputs, function		GF54.21-D-5025TSA
	Caravan control unit parameters of digital inputs, function		GF54.21-D-5027TSA
	Caravan control unit parameters of digital outputs, function		GF54.21-D-5028TSA
	Overview of system components of caravan control unit	Model 907, 910	GF54.21-D-9992TSA
	Overview of system components of caravan control unit	Model 447	GF54.21-S-9992TMA