Retrofit Antenna Module For Audio 40 With Digital Radio (DAB) - AN82.85-S-0015-01E
Model 447.6/7
with code JF1 (rain sensor)
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notice | Notes on carrying out repair work in the vehicle interior | AH68.00-D-0001-01KOS |
- Loosen tape (1) at right A-pillar and detach electrical plug (2).
- Attach antenna module (3) to right A-pillar and fasten with integrated screw.
- Connect electrical plug (2) to antenna module (3).
- Route electric line for antenna module (3), as shown, from right A-pillar, inside instrument panel up to installation location of audio 40.
Do not kink electric line and ensure that it is routed without any chafing.
This will prevent damage occurring.
- Secure electric line for antenna module (3) section by section using cable ties at factory-installed electrical wiring harness.
- Connect plug holder (4) to antenna module (3).
The contact socket (5) of electric line for antenna module (3) is connected when installing audio 40.