Attach Model Badge To Rear-End Door - AR72.15-S-0001E

Model 447.6/7 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Shown On Model 447.6 With Code ZG2 (All-wheel drive, permanent) 

Courtesy of MERCEDES-BENZ USA

Shown On model 447.7 

Courtesy of MERCEDES-BENZ USA

Shown On Model 447.7 With Code ZU8 (National version USA) 

	Clean
1	Clean rear-end door in area of bonding surface of model badge (1)	The bonding surface must be dry, free of dust and grease. Otherwise sufficient adhesion of the model badge (1) is not ensured. Cleaner	*BR00.45-Z-1025-04A
	Install model designation
2	Mask model badge (1) with adhesive tape (2)	To fasten individual letters and numbers of model badge (1).
3	Attach adhesive tape to rear-end door according to dimensions	Adhesive tape serves as installation aid.
4	Heat rear-end door in area of bonding surface on model badge (1) to approx. 40°C
5	Remove carrier foil (3)	The individual letters and numbers on the model badge (1) must remain fastened to the adhesive tape (2).
6	Align corresponding model badge (1) according to rear-end door and glue on	Glue on model badge (1) only at a room temperature of approx. 20°C. Otherwise adhesion problems may occur.
7	Remove adhesive tape (2) from model badge (1)
8	Remove adhesive tape to position model badge (1) on rear-end door
	Clean
9	Remove adhesive residues from rear-end door	Cleaner	*BR00.45-Z-1025-04A