LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> Metris Van Cargo >> Repair and Diagnosis >> Body & Frame >> Mirrors >> Interior Equipment -- 447 Chassis >> Testing & Repair >> Remove/Install Curtain For Side Window In Rear - AR68.50-S-7816E

Remove/Install Curtain For Side Window In Rear - AR68.50-S-7816E

Model 447.7 

With Code ZH6 (Marco Polo ACTIVITY) 

G16507230Courtesy of MERCEDES-BENZ USA

Shown On right side window in rear 

Notice  Notes on carrying out repair work in the vehicle interior   AH68.00-D-0001-01KOS 
REMOVINGINSTALLING Remove/install     
1 Completely move passenger bench seat toward rear    
2 Remove coat hook (2) from B-pillar Model 447.7
with code ZH6 (Marco Polo ACTIVITY)
except code T19 (Sliding door left)
When removing curtains (1) from left front window.
 
3 Detach curtains (1) at push buttons (3) from window frame paneling Model 447.7
with code T19 (Sliding door left)
with code ZH6 (Marco Polo ACTIVITY)
When removing curtains (1) from side window in left and right sliding door.
 
4 Detach curtains (1) from push-buttons (3) on B-pillar paneling and C-pillar paneling Model 447.7
with code ZH6 (Marco Polo ACTIVITY)
except code T19 (Sliding door left)
When removing curtains (1) from left front window.
 
5 Remove coat hooks (2) from C-pillar When removing curtains (1) on left and right rear side window.  
6 Detach curtains (1) at push-buttons (3) on C-pillar paneling and D-pillar paneling When removing curtains (1) on left and right rear side window.  
7 Unclip cover (4) by hand    
8 Mark installation position of curtain rod (5) Not when replacing curtain rod (5).
IMPORTANT The curtain rod (5) may be bent upward slightly on some vehicles.
 
9 Remove bolt (6) INSTALLATION IMPORTANT : Observe marking of installation position on curtain rod (5) before screwing in bolt (6). Install curtain rod (5) with bending pointing upward.
If the curtain rod (5) is installed in the new paneling without a hole for the bolt (6), center curtain rod (5) before screwing bolt (6).
 
10 Remove spacers (7)    
11 Slide curtain rod (5) to left or right into corresponding paneling until the other end of the curtain rod (5) is moved out the paneling    
12 Pull curtain rod (5) out of corresponding paneling together with curtains (1)    
13 Remove curtains (1) from curtain rod (5) Only when replacing curtains (1) or curtain rod (5).  
14 Install in the reverse order