Remove/Install Rear Stabilizer Bar Linkage - AR32.35-P-3329ME
Model 167
except code 489 (AIRMATIC Dual Control/semi-active air suspension)
except code 490 (Electrohydraulic suspension)
Model 167
with code 489 (AIRMATIC Dual Control/semi-active air suspension)
except code 490 (Electrohydraulic suspension)
Fig 1: Rear Stabilizer Bar Linkage Components Location - With/Without Code 489 Except Code 490 (Right Side Shown)
Shown on right side of vehicle
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove/install | |||
| 1 | Remove right or left rear wheel and tire assembly. | AR40.10-P-1102ME | |
| 2 | Remove nut (3) from stabilizer bar (2). | ||
| Notice | Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | |
Model 167 with code 465 (Electric Active Roll Stabilization (EARS)) with code 489 (AIRMATIC Dual Control/semi-active air suspension) except code 490 (Electrohydraulic suspension) Nut, torsion bar linkage to stabilizer bar |
*BA32.35-P-1003-03E | ||
| 3 | Remove screw (4) from transverse control arm (5). | Model 167 with code 465 (Electric Active Roll Stabilization (EARS)) with code 489 (AIRMATIC Dual Control/semi-active air suspension) except code 490 (Electrohydraulic suspension) Screw/nut, stabilizer to spring link |
*BA32.35-P-1002-03E |
| 4 | Remove torsion bar linkage (1). | ||
| Check | |||
| 5 | Check torsion bar linkage (1) for damage and wear. | If torsion bar linkage (1) is reused. If there is a problem, ↓ replace torsion bar linkage (1). |
|
| 6 | Install in the reverse order. |
REAR AXLE STABILIZER BAR
| Number | Designation | Model 167 except code 465 (Electric Active Roll Stabilization (EARS)) except code 489 (AIRMATIC Dual Control/semi-active air suspension) | Model 167 with code 465 (Electric Active Roll Stabilization (EARS)) with code 489 (AIRMATIC Dual Control/semi-active air suspension) | |
|---|---|---|---|---|
| BA32.35-P-1002-03E | Screw/nut, stabilizer to spring link | Nm | 100 | 100 |
REAR AXLE STABILIZER BAR
| Number | Designation | Model 167 except code 465 (Electric Active Roll Stabilization (EARS)) except code 489 (AIRMATIC Dual Control/semi-active air suspension) | Model 167 with code 465 (Electric Active Roll Stabilization (EARS)) with code 489 (AIRMATIC Dual Control/semi-active air suspension) | |||
|---|---|---|---|---|---|---|
| BA32.35-P-1003-03E | Nut, torsion bar linkage to stabilizer bar | Stage 1 | Nm | 100 | 100 | |
| Stage 2 | Loosen | ∠° | 180 | 180 | ||
| Stage 3 | Nm | 40 | 40 | |||
| Stage 4 | ∠° | 80 | 80 | |||