Drain/Pour In Front Axle Gear Oil - AR33.25-P-0300-01OID
Model 167
FRONT AXLE GEAR
| Number | Designation | Model 167 | |
|---|---|---|---|
| BA33.30-P-1002-03H | Front axle transmission filling screw | Nm | 35 |
FRONT AXLE GEAR
| Number | Designation | Model 167 | |
|---|---|---|---|
| BA33.30-P-1003-03H | Front axle transmission drain screw | Nm | 35 |
FRONT AXLE GEAR
| Number | Designation | Model 167 | ||
|---|---|---|---|---|
| BF33.30-P-1002-03D | capacity | Front axle differential 177 | Liter | 0, 55 |
| Front axle differential 198 | Liter | 0, 65 | ||
| Overview of axle gear oils | BB00.40-P-0231-01A | |||
| Approved axle gear oils | BB00.40-P-0235A | |||
| Universal hypoid gear oil | BB00.40-P-0235-07A | |||
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1046-04A | Loctite 7063 (400 ml) cleaning spray | A 001 986 71 71 09 |
| BR00.45-Z-1110-02A | Quick-acting adhesive Omnifit 100H (50 g) | A 002 989 23 71 |
Example illustration
Drain off
- Remove filling screw (3).
- Remove drain screw (2) and collect hypoid gear oil in a suitable container.
Pour in
- Clean and degrease thread of drain screw (2) and filling screw (3) in housing of front axle differential (1) using Loctite 7063 cleaning spray.
- Coat first pitch of thread of drain screw (2) with Omnifit 100H quick-acting adhesive.
- Screw in drain screw (2) and tighten to specified torque
- Fill hypoid gear oil using
hand pump
.
With the correct oil level the oil reaches up to the bottom edge of the threaded hole.
If necessary, add oil or drain off oil until the oil only drips out of the threaded hole.
- Coat first pitch of thread of filling screw (3) with Omnifit 100H quick-acting adhesive.
- Screw in filling screw (3) and tighten to specified torque
.