Remove/Install Seats In Rear Passenger Compartment - AR91.12-P-4026ME

Model 167.1 

with code 567 (Vario rear seat) 

Model 167.9 

except code M036 (Maybach version) 

Courtesy of MERCEDES-BENZ USA

Shown on left-hand drive vehicle, model 167.1 with code 567 (Vario rear bench seat) 

Shown on left-hand drive vehicle, model 167.9 with code 226 (7 seats with 3rd seat row) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  . Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Swivel seat backrest of corresponding rear seat forward.
2	Apply suitable protection to rear door sills.
3	Remove load compartment cover.	Model 167.1 with code 541 (Combined luggage cover incl. safety net) with code 567 (Vario rear seat) Model 167.1 with code 567 (Vario rear seat) with code 723 (Load compartment cover) Model 167.9 except code M036 (Maybach version)
4	Remove partitioning net for luggage retainer.	Model 167.1 with code 541 (Combined luggage cover incl. safety net) with code 567 (Vario rear seat) Model 167.1 with code 567 (Vario rear seat) with code U40 (Safety net for luggage cover) Model 167.9 with code U40 (Safety net for luggage cover) except code M036 (Maybach version)
5	Move rear seat forward until the screws (4) are accessible.
6	Remove screws/bolts (4).	Bolt, guide rail for rear seat to body	*BA91.12-P-1013-03M
7	Move rear seat to rearmost position.
8	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
9	Disconnect ground line from on-board electrical system battery.	Model 167.1 with code 293 (Sidebag in rear left and right) with code 567 (Vario rear seat) Model 167.9 with code 293 (Sidebag in rear left and right) except code M036 (Maybach version)	AR54.10-P-0003ME
10	Remove cover (1) from rear seat.	Model 167.1 with code 567 (Vario rear seat) Model 167.9 with code 224 (Rear individual seat design) except code M036 (Maybach version)
11	Remove covers (2) of front guide rails.
12	Remove screw/bolts (3).	Bolt, guide rail for rear seat to body	*BA91.12-P-1013-03M
13	Tilt rear seat backward until the electrical connectors (5) are accessible.
14	Release and disconnect electrical connectors (5) and unclip electrical wiring harness (6) at rear seat.	The number of electrical connectors (5) varies depending on the vehicle equipment.
15	Remove rear seat.	When removing the rear seat, do not touch any trim parts in the vehicle. Otherwise they may be damaged. Helper required.
16	Install in the reverse order.