Remove/Install Side Load Compartment Paneling - AR68.30-P-1185MEM

Model 167.9 

With Code M036 (Maybach version) 

Shown on right load compartment trim (4) 

Courtesy of MERCEDES-BENZ USA

Shown on right load compartment trim (4) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
2	Remove refrigerator box.	Model 167.9 with code 308 (Refrigerated compartment in rear passenger compartment) with code M036 (Maybach version)	AR86.61-P-1010MEX
3	Remove holder of electrical connector for refrigerator box from trim (1).
4	Remove trim (1).
5	Remove rear-end center-section trim.		AR68.30-P-4786ME
6	Unclip front load compartment floor (2) and remove from vehicle.	Long wedge	Fig 2
7	Remove screw at hinges of rear load compartment floor (3).	Screw, rear load compartment floor to crossmember	*BA68.30-P-1003-01G
8	Remove rear load compartment floor (3) from vehicle.
9	Remove cargo retainers (5).	Bolt, cargo retainers to body	*BA68.50-P-1001-03F
10	Release edge guard in area of load compartment trim (4).
11.1	Unclip left load compartment trim (4) (arrows) and remove.	When removing left load compartment trim (4). Long wedge	Fig 2
11.2	Unclip right load compartment trim (4) (arrows), disconnect electrical connectors (6), and remove right load compartment trim (4).	When removing right load compartment trim (4). Long wedge	Fig 2
12	Remove rear-end lowering switch (S105) from right load compartment trim (4).	When replacing right load compartment trim (4).
13	Remove trunk socket (X58/12) from right load compartment trim (4).	When replacing right load compartment trim (4). Pliers	Fig 3
14	Unclip damping behind load compartment trim (4) and remove.	If necessary. Dismantling tool	Fig 1
15	Install in the reverse order.

Fig 1: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Pliers (169 589 00 37 00)

Courtesy of MERCEDES-BENZ USA