Adjust Wiper Arms - AR82.30-P-6100-01MEB
Model 167, 223, 232 Except Code 874 (MAGIC VISION CONTROL incl. heated windshield washer system)
| Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism. | When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m). | AS82.30-Z-0001-01A | |
| Notes on wiper arm adjustment | AH82.30-P-0001-01A |
| Number | Designation | Model 167 | ||
|---|---|---|---|---|
| BE82.30-P-1003-01J | Angle of incidence of driver-side wiper arm in parked position | Left-hand drive vehicle | ∠° | +2, 0...+6, 0 |
| Right-hand drive vehicle | ∠° | -2, 0...-6, 0 | ||
| Number | Designation | Model 232 | ||
|---|---|---|---|---|
| BE82.30-P-1003-01L | Angle of incidence of driver-side wiper arm in parked position | Left-hand drive vehicle | ∠° | -4, 4...-6, 4 |
| Right-hand drive vehicle | ∠° | +4, 4...+6, 4 | ||
| Number | Designation | Model 223 except code 874 (MAGIC VISION CONTROL incl. heated windshield washer system) | ||
|---|---|---|---|---|
| BE82.30-P-1003-01M | Angle of incidence of driver-side wiper arm in parked position | Left-hand drive vehicle | ∠° | +3, 0...+7, 0 |
| Right-hand drive vehicle | ∠° | -3, 0...-7, 0 | ||
| Number | Designation | Model 167 | ||
|---|---|---|---|---|
| BE82.30-P-1004-01J | Angle of incidence of passenger-side wiper arm in parked position | Left-hand drive vehicle | ∠° | +2, 0...+6, 0 |
| Right-hand drive vehicle | ∠° | -2, 0... -6, 0 | ||
| Number | Designation | Model 232 | ||
|---|---|---|---|---|
| BE82.30-P-1004-01L | Angle of incidence of passenger-side wiper arm in parked position | Left-hand drive vehicle | ∠° | -4, 5...-6, 5 |
| Right-hand drive vehicle | ∠° | +4, 5...+6, 5 | ||
| Number | Designation | Model 223 except code 874 (MAGIC VISION CONTROL incl. heated windshield washer system) | ||
|---|---|---|---|---|
| BE82.30-P-1004-01M | Angle of incidence of passenger-side wiper arm in parked position | Left-hand drive vehicle | ∠° | +2, 7...+6, 7 |
| Right-hand drive vehicle | ∠° | -2, 7...-6, 7 | ||
Use the following special tools:
Angle gauge from
adjustment tool set
Adjustment lever (Z4) from
adjustment tool set
Adapter
Attach angle gauge (A) with
adapter (E) at wiper arm to be adjusted.
- Position
adjustment levers (Z4) as far apart from one another as possible on wiper arm to be adjusted. Cross
adjustment levers (Z4) in required direction until correct set value on scale of
angle gauge (A) is achieved.
Wiper arms are crossed axially using
adjustment lever (Z4) positioned near to
angle gauge (A). The second
adjustment lever (Z4) is used as a counterholder.
- Remove
adjustment levers (Z4) from wiper arm.
- Read angle of incidence of adjusted wiper arm on scale of
angle gauge (A), and compare with adjustment value. Model 167
except code 874 (MAGIC VISION CONTROL incl. heated windshield washer system)
Model 223 except code 874 (MAGIC VISION CONTROL incl. heated windshield washer system)
Model 167 except code 874 (MAGIC VISION CONTROL incl. heated windshield washer system)
Model 223 except code 874 (MAGIC VISION CONTROL incl. heated windshield washer system)
Model 232 except code 874 (MAGIC VISION CONTROL incl. heated windshield washer system)
Model 232 except code 874 (MAGIC VISION CONTROL incl. heated windshield washer system)
If a deviation is present.
↓
correct angle of incidence.
Remove angle gauge (A) with
adapter (E) from adjusted wiper arm.
- Repeat adjustment procedure on wiper arm not yet adjusted.
If required.
Shown on driver-side wiper arm in parked position