Remove/Install Pre-fuse Box In Footwell On Passenger Side - AR54.15-P-1351ME
Model 167
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove floor covering at front on front passenger side. | AR68.80-P-0008ME | |
| 2 | Clamp off ground line of on-board electrical system battery (G1). | AR54.10-P-0003ME | |
| 3 | Unscrew nuts (1). | ||
| 4 | Lift cover (2) slightly at arrow and remove cover (3). | ||
| 5 | Open cover (4) and disconnect positive line underneath. | Model 167 with code B01 (48V technology) | |
| *BA54.15-P-1001-01L | |||
| 6 | Unclip cover (5) and remove. | ||
| 7 | Expose and disconnect positive line underneath. | ||
| *BA54.15-P-1001-01L | |||
| 8 | Release catch tabs (7) on undersides of power distributor strips (6), unclip power distributor strips (6) in direction of arrow (A) and place to one side. | ||
| 9 | Squeeze retaining lugs of catch (8) together at top and remove catch (8) upwards. | ||
| 10 | Unlock vehicle interior prefuse box (F150/2) (arrows B), lift out from body openings and turn over as far as possible. | ||
| 11 | Unclip cover (9) on underside of vehicle interior prefuse box (F150/2). | ||
| 12 | Expose and disconnect positive line underneath. | *BA54.15-P-1001-01L | |
| 13 | Install in the reverse order. |
FUSE AND RELAY BOX
| Number | Designation | Model 167 | ||
|---|---|---|---|---|
| BA54.15-P-1001-01L | Nut, positive line to engine compartment/vehicle interior prefuse box | M6 | Nm | 8 |
| M8 | Nm | 16 | ||