Remove/Install Park Pawl Capacitor - AR54.10-P-1126ME

Model 167 

Fig 1: Park Pawl Capacitor Components Location - Model 167

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Remove front floor covering on passenger side.		AR68.80-P-0008ME
2	Remove air ducts (1).
3	Remove trim at bottom of B-pillar.		AR68.30-P-4700ME
4	Fold back floor covering (2).
5	Unclip expansion rivets (3).	Dismantling tool	Fig 2
6	Remove air duct (4).
7	Remove nuts (5).
8	Remove the cover (6).
9	To gain access to the park pawl capacitor (C8), release and disconnect the electrical connectors at the head unit (A26/17).	Model 167 with code 548 (Connect 20 MID (NTG6)) Model 167 with code 549 (Connect 20 HIGH (NTG6))
			AR82.85-P-1101ME
		It is not necessary to separate all the electrical connectors.
10	Release and disconnect electrical connector from park pawl capacitor (C8).
11	Unclip and remove park pawl capacitor (C8).
12	Install in the reverse order.

Fig 2: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA