Remove/Install Upper Liftgate Trim - AR72.20-P-6631FRX
Model 290
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic | AH54.00-P-0001-01A | |
| components due to electrostatic discharge | |||
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove lower liftgate trim. | AR72.20-P-6617FRX | |
| 2 | Detach and remove rear shelf. | ||
| 3 | Unclip upper center liftgate trim (1) at the retaining clips (arrow A) on the liftgate (4) and on the upper liftgate trim (2, 3) and remove. | Fig 1 | |
| 4 | Unclip left upper liftgate trim (2) at the retaining clips (arrow B) and remove. | Fig 1 | |
| 5 | Unclip right upper liftgate trim (3) at the retaining clips (arrow C) and remove. | Fig 1 | |
| 6 | Install in the reverse order. |