Perform Additional Operations When Removing Inner Side Wall Trim - AR68.30-P-4780-03FR

Model 290 with code 287 (Through-loading feature) 

Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.

AS00.00-Z-0017-01A

1. On the side trim (1), as shown, create an elongated hole for the drift (5) of the bracket (2).

   The reference point for the dimension (a) is the reinforcement (arrow D) of the side trim (1). The reference point for the dimension (b) is the outer edge (arrow E) of the side trim (1).

   Dimension (a): 50.3 mm.

   Dimension (b): 33.3 mm.

   Dimension (c): 9.4 mm.

   Dimension (d): 4.3 mm.

   Shown on the left side trim 

   Courtesy of MERCEDES-BENZ USA

2. Attach clamp (3) to the bracket (2).

   Shown on the left side trim 

   Courtesy of MERCEDES-BENZ USA

3. Fasten the bracket (2) above the drift (5) using the retaining washer (4).

   Check bracket (2) for tight seating.

   Shown on the left side trim 

   Courtesy of MERCEDES-BENZ USA