Remove/Install Front Floor Covering On Driver's Side - AR68.80-P-0007FR

Model 257 

Model 290 

Shown on model 257 

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove floor mat.
2	Release driver's seat and tilt toward the rear.	Do not disconnect electrical connectors.	AR91.10-P-1000FR
3	Remove trim under driver's side instrument panel.		AR68.10-P-1501FR
4	Remove accelerator pedal (3).		AR30.12-P-1321FR
5	Remove door sill (2).
6	Remove floor covering (1) from the front to the rear.	Position floor covering (1) below center console. Long wedge	Fig 1
7	Install in the reverse order.

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA