Remove/Install Parktronic System (PTS) Sensors In Front Bumper - AR54.65-P-0001FR
Model 257, 290
with code 235 (Active Parking Assist)
Shown on removed front bumper on model 257
Fig 1: Parktronic System (PTS) Sensors In Front Bumper Components Location - Model 290 With Code 235 (Shown On Model 257)
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Remove service flap at front fender liner. | When removing front parking system distance sensor (B8/1, B8/6). | |
| 2 | Remove front bumper. | When removing front parking system distance sensor (B8/2, B8/3, B8/4, B8/5). | AR88.20-P-2000FR |
| 3.1 | Remove impact absorber from front bumper. | Model 257, 290 with code 235 (Active Parking Assist) except code U60 (Pedestrian protection - Active hood) |
|
| When removing front parking system distance sensor (B8/2, B8/3, B8/4, B8/5). | |||
| Notice | General information on the impact absorber | AH88.20-P-1000-01A | |
| 3.2 | Remove front bumper crash sensor together with impact absorber from front bumper. | Model 257, 290 with code 235 (Active Parking Assist) with code U60 (Pedestrian protection - Active hood) |
|
| When removing front parking system distance sensor (B8/2, B8/3, B8/4, B8/5). | |||
| Notice | General information on the impact absorber | AH88.20-P-1000-01A | |
| Notice | Notes on pedestrian protection sensor | AH91.60-P-0001-01A | |
| AR91.60-P-0950FR | |||
| 4 | Release and disconnect electrical connector (1) at front parking system distance sensor (B8/1, B8/2, B8/3, B8/4, B8/5, B8/6). | ||
| 5 | Release catch hooks of corresponding holder (2) in direction of arrow then remove front parking system distance sensor (B8/1, B8/2, B8/3, B8/4, B8/5, B8/6) from holder (2). | ||
| Notice | Information on painting PARKTRONIC system sensors | AH98.00-P-9019-02A | |
| If there is a problem, ↓ Replace relevant seal (3). |
|||
| 6 | Install in the reverse order. |