Remove/Install 12V Socket At Front Of Vehicle Interior - AR54.10-P-1003FRX

Model 290 

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch off ignition and store transmitter key outside of transmission range (min. 2 m).
2	Open stowage compartment cap (1).
3	Open flap (2) on vehicle interior socket at front (X58/17).
4	Use pliers (3) to release vehicle interior socket at front (X58/17) and pull out far enough to gain access to electrical connector of vehicle interior socket at front (X58/17).	The studs of the pliers (3) must engage in the cutouts of the housing of the vehicle interior socket at the front (X58/17) (arrows A).
		Align the flap (2).
		Pliers	Fig 1
5	Disconnect electrical connector from vehicle interior socket at front (X58/17) and remove vehicle interior socket at front (X58/17).
6	Install in the reverse order.

Fig 1: Identifying Pliers (169 589 00 37 00)

Courtesy of MERCEDES-BENZ USA