Programming Of Control Units - AR54.21-P-0014LWO

Model 190 

Model 238 

Model 257 

Model 290 

Model 293 

	Notes on programming control units		AH54.21-P-0001-03Z
	Programming
1	Connect vehicle diagnosis system, start XENTRY and select vehicle model.
		Model 190	AD00.00-P-2000-04B
		Model 238	AD00.00-P-2000-06LWO
		Model 257, 290, 293	AD00.00-P-2000-06FR
2	Select control unit.
3	Select menu item "control unit adaptations".
4	Select menu item "control unit programming".
5	Confirm notes on control unit programming specific to a single control unit.
6	Select menu item "Online".
7	Confirm procedure.
8	Enter reason for control unit programming.
9	Run through programming sequence based on menu indications in XENTRY.
10	Rectify fault using test steps in "Error messages" menu.	For communication errors between XENTRY and control unit.
		If the fault cannot be rectified: ↓ Notify Star Diagnosis User Help Desk.
11	Perform SCN coding of control unit.	With corresponding specification through XENTRY.
			AR54.21-P-0015X
12	Perform teach-in processes.	With corresponding specification through XENTRY.
13	Read out and delete fault memories.
14	Disconnect diagnostic system.
		Model 190	AD00.00-P-2000-04B
		Model 238	AD00.00-P-2000-06LWO
		Model 257, 290, 293	AD00.00-P-2000-06FR