Remove Pilot Bushing - AR41.10-P-0250-02MNI

Model 290 

Measure 

1. Measure dimension (a) and note down for installation.

   Courtesy of MERCEDES-BENZ USA

   Remove 

2. Pound pilot bushing (10) using flat chisel uniformly out of propeller shaft (arrow).

   Courtesy of MERCEDES-BENZ USA

3. Drill a hole 15 mm removed from the front side of the pilot bushing (10), (Ø 10 mm) at a right angle through the pilot bushing (10).

   If pilot bushing (10) is seized.

   Courtesy of MERCEDES-BENZ USA

4. Insert suitable drift through hole and pry pilot bushing (10) out of propeller shaft using two assembly levers.

   If pilot bushing (10) is seized.

   Courtesy of MERCEDES-BENZ USA