Remove/Install Trim Piece On Passenger Side Instrument Panel - AR68.10-P-1187FR
Model 257, 290
Shown on model 257.### 1# with code 891 (Premium ambient lighting)
Shown on model 257 with code 891 (Premium ambient lighting)
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Move steering wheel all the way to the rear and to the bottom. | ||
| 2 | Disconnect ground line from battery. | AR54.10-P-0003FR | |
| 3 | Release edge guard in the area of the cover (10). | ||
| 4 | Remove cover (10). | Fig 1 | |
| 5 | Remove display module (8) and place to one side with connected electric lines. | AR54.30-P-6023FR | |
| 6 | Unclip front passenger side trim piece (9) along the entire length at the bottom. | ||
| Fig 1 | |||
| 7 | Tilt front passenger side trim piece (9) slightly toward the top and guide out of the instrument panel. | ||
| 8 | Detach electrical connector (7). | ||
| 9 | Disconnect light-emitting diodes (6, 11, 12) from the fiber-optic cables. | Model 257, 290 with code 891 (Premium ambiance illumination) |
|
| 10 | Remove front passenger side trim piece (9). | ||
| 11 | Remove KEYLESS-GO start/stop button. | When replacing front passenger side trim element (9). | |
| AR54.25-P-4000FR | |||
| 12 | Remove center air vent. | When replacing front passenger side trim element (9). | |
| AR83.10-P-4509FR | |||
| 13 | Install in the reverse order. |