Remove/Install Engine Sound Generator And Control Unit - AR82.27-P-0002LSE
Model 290 with code ME10 (Hybrid vehicle (plug-in, PHEV))
| Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | AS00.00-Z-0009-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Fold up load compartment floor rear section and fix in place. | ||
| 3 | Remove intermediate bottom. | Fig 2 | |
| 4 | Release and disconnect electrical connector (1) at electric drive front sound generator control unit (N12/2) or at electric drive rear sound generator control unit (N12/3). | ||
| 5 | Remove electrical wiring harness (3) at electric drive front sound generator control unit (N12/2). | When removing electric drive front sound generator control unit (N12/2). | |
| 6 | Remove nuts (2) at electric drive front sound generator control unit (N12/2) or at electric drive rear sound generator control unit (N12/3). | ||
| 7 | Remove electric drive front sound generator control unit (N12/2) or electric drive rear sound generator control unit (N12/3). | ||
| 8 | Install in the reverse order. | ||
| Check | |||
| 9 | Commission electric drive front sound generator control unit (N12/2) or electric drive rear sound generator control unit (N12/3). | When replacing electric drive front sound generator control unit (N12/2) or electric drive rear sound generator control unit (N12/3). | |
| AD00.00-P-2000-06FR |