Remove/Install Parktronic System (PTS) Sensors In Rear Bumper - AR54.65-P-0002FR
Model 257, 290
with code 235 (Active Parking Assist)
Shown on removed rear bumper on model 257
Fig 1: Parktronic System (PTS) Sensors In Rear Bumper Components Location - Model 290 With Code 235 (Shown On Model 257)
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1.1 | Remove appropriate rear fender liner. | Model 290 with code 235 (Active Parking Assist) For removal of rear parking system distance sensors (B8/7, B8/10). |
AR88.10-P-1302FR |
| 1.2 | Remove rear bumper. | Model 290 with code 235 (Active Parking Assist) When removing the rear parking system distance sensors (B8/8, B8/9, B8/11, B8/12) or when removing all the rear parking system distance sensors (B8/7, B8/8, B8/9, B8/10, B8/11, B8/12) |
AR88.20-P-2200FRX |
| 2 | Remove rear bumper. | Model 257 with code 235 (Active Parking Assist) |
AR88.20-P-2200FR |
| 3 | Release and disconnect electrical connector (1) at rear parking system distance sensor (B8/7, B8/8, B8/9, B8/10, B8/11, B8/12). | ||
| 4 | Release catch hooks of corresponding holder (2) in direction of arrow and remove rear parking system distance sensor (B8/7, B8/8, B8/9, B8/10, B8/11, B8/12) from holder. | ||
| Notice | Information on painting PARKTRONIC system sensors | AH98.00-P-9019-02A | |
| If there is a problem, ↓ Replace relevant seal (3). |
|||
| 5 | Install in the reverse order. |