Settings On Workshop Level, Function - GF54.30-P-2020FR
Model 257, 290
up to model year 2021
Function requirements in general
- Circuit 15R ON
The electronic ignition lock control unit (N73) transmits the status of circuit 15 via the user interface CAN (CAN HMI) to the instrument cluster (A1).
Workshop level adjustments, general
The workshop level is used by technicians in the workshop for reading out vehicle and service data and provides assistance with carrying out the service.
The Workshop menu is activated as follows:
- Select Total distance in the Trip menu.
- Press and hold the Home and Back button (S163/1 s14) for t = 1.5 s, then press the finger navigation pad on the instrument cluster (S163/1s10).
The instrument cluster switches to the Workshop menu. Wiping from top to bottom and vice versa in the submenus enables you to scroll through the submenus or lists. Selection is then made by pressing on the instrument cluster finger navigation pad.
The request is read in by the steering wheel electronics (N135) and sent over the steering LIN (LIN E1) to the steering column tube module control unit (N80). The steering column tube module control unit sends this request to the instrument cluster via chassis FlexRay (Flex E), electronic ignition lock control unit and user interface CAN.
The following menus are accessible:
- Vehicle data
- Dynamometer test
- Lining change mode
- ASSYST PLUS
- Head-up-display (with code 463 (Head-up display))
Vehicle data
The following data can be called up in the Vehicle data menu:
- Voltage (in V)
- Current (in A)
- Temperature (in °C )
- Engine data (e.g. engine number)
- Vehicle identification number (VIN)
Dynamometer test
Activating the dynamometer test prevents faults from being entered in the Electronic Stability Program control unit (N30/4) during the brake test on the roller dynamometer.
The following settings can be selected in the "Dynamometer test" menu:
- On
- Off with circuit 15 OFF
If the workshop menu is left and the "Dynamometer test" menu was not deactivated prior to this, it will be automatically called up during the next ignition cycle.
Lining change mode
The following settings can be selected in the Lining change mode:
- OK
- Move to assembly position
ASSYST PLUS
The following information can be called up in ASSYST PLUS:
- Service data
- Full service
- Vehicle hand over
- Oil measurement
Head-up-display (with code 463 (Head-up display))
The Head-up display menu can be used to configure head-up display.
The settings can be checked using a test image.
| Overview of system components, instrument cluster (IC) component description | GF54.30-P-9996FR |