Remove/Install Front Pre-fuse Box - AR54.15-P-1330ME

Model 167 

Fig 1: Front Pre-fuseBox Components Location - Model 167

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Shown on model 167 with engine 656 

Shown on model 167 with engine 656 

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Clamp off ground line of on-board electrical system battery (G1).		AR54.10-P-0003ME
2	Remove cover (1).		AR83.10-P-1411ME
3	Unclip cover (2) (arrows) and remove.
4	Unscrew nut (4), expose associated electric lines and remove.	The number of electrical lines varies depending on the vehicle equipment.
		Nut, positive line to engine compartment/vehicle interior prefuse box	*BA54.15-P-1001-01L
5	Unscrew nuts (5).
6	Cut through cable ties (6).	Replace cable ties (6).
7	Unclip electrical connector (7) from engine compartment prefuse box (F150/3).	Do not release and disconnect electrical connector (7).
8	Remove engine compartment prefuse box (F150/3) as far as possible and turn.
9	Unclip cover (8) (arrows) and remove.
10	Unscrew nuts (9), expose associated electric lines and remove engine compartment prefuse box (F150/3).	The number of electrical lines varies depending on the vehicle equipment.
		Nut, positive line to engine compartment/vehicle interior prefuse box	*BA54.15-P-1001-01L
11	Install in the reverse order