Remove/Install Wind Deflector For Panoramic Sliding Sunroof - AR77.21-P-0101ME

Model 167.1/9 

With Code 413 (Panoramic sliding sunroof/glass roof) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1	Move front seats to rearmost position.
2	Completely open panoramic sliding sunroof.
3	Remove front inside seal (1).		AR77.21-P-0560ME
4	Unclip bottom element of the wind deflector (5 from the retaining clips (K) on the roof frame, release catch lugs (8), pull bottom element slightly toward the rear, and remove from the roof frame.	Ensure that the retaining clip (K) and catch lugs (8) are seated correctly. Ensure that the guides (4) of the wind deflector (5) are seated correctly under the guide rails (7) of the roller sunblind.	s
5	Remove springs (2).
6	Guide supports (3) of the wind deflector (5) out of the side bearings of the wind deflector (6) and remove.
7	Place wind deflector (5) and lower part together vertically (arrow A), guide out of the side bearings of the wind deflector (6), and remove.
	Check
8	Check retaining clips (K) for damage.	If damage is present on the retaining clips (K), ↓ replace wind deflector (5).
9	Install in the reverse order.