Remove/Install Front Panoramic Glass Roof - AR77.21-P-0500ME

Model 167.1/9 

With Code 413 (Automatic panoramic sliding sunroof) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove
1	Unclip front trims from the sliding roof panel (2) and remove.		AR77.21-P-6920ME
2	Mark position of the screws (1, 3).	The instructions are shown only for one side and must be carried out on both sides.
3	Remove screws (1, 3).	The instructions are shown only for one side and must be carried out on both sides.
4	Remove sliding roof panel (2) upward and set down on a suitable base.	Helper required.
	Install
5	Place sliding roof panel (2) on the marked positions and tighten screws (1) slightly by hand.	The instructions are shown only for one side and must be carried out on both sides. Helper required.
6	Close sliding roof panel (2) and check gap dimension from outside with a helper; if necessary, loosen screws (1) (put into tilt position again) and carry out fine adjustment while the sliding roof panel is closed (2).	Helper required.	AR77.21-P-6924ME
7	Tighten screw (3).	The instructions are shown only for one side and must be carried out on both sides. Screw, sliding roof panel to sliding roof	*BA77.21-P-1002-01F
8	Tighten screws (1).	The instructions are shown only for one side and must be carried out on both sides. Screw, sliding roof panel to sliding roof	*BA77.21-P-1002-01F
9	Install front trims on the sliding roof panel (2).		AR77.21-P-6920ME
	Concluding tasks
10	Normalize panoramic sliding sunroof using vehicle diagnosis system and perform teach-in run for automatic reversing function.
			AD00.00-P-2000-06ME