Welding Device Installation - Ar62.20-P-1286-05ME

Model 167 

Fig 1: Welding Device (167 589 00 23 00)

Courtesy of MERCEDES-BENZ USA

The higher-level service document as well as the safety information in the service document must be observed.

Courtesy of MERCEDES-BENZ USA

Required parts of welding fixture 

The following operation steps are shown on the left side of the vehicle. In case of damage on the right side of the vehicle, these steps must be performed analogously with the corresponding parts of the welding fixture.

Courtesy of MERCEDES-BENZ USA

Shown on installed suspension strut 

Courtesy of MERCEDES-BENZ USA

Shown on removed suspension strut 

1. Unscrew nuts (3).

   With suspension strut installed.

2. 1. With suspension strut installed.

      Unscrew spacers sleeves (2a) on threaded pins f suspension turret web.

   2. With suspension strut removed.

      Install spacers sleeves (2a) on suspension strut tower with bolts (2b).

      Tighten bolts (2b) slightly by hand.

3. Mount carrier plate (2) on spacer sleeves (2a).
4. Slightly manually screw screws (2c) into spacer sleeves (2a).
5. Fix extension 1L (1a) with cylinder pin (1k) in place on carrier plate (2) using the specified guides.
6. Fix extension 3L (1b) with cylinder pin (1k) in place on carrier plate (2) using the specified guides.
7. Fix extension 4L (1c) with cylinder pin (1k) in place on carrier plate (2) using the specified guides.
8. Fix extension 2L (1d) with cylinder pin (1k) in place on carrier plate (2) using the specified guides.
9. Tighten bolts (2b).

   With suspension strut removed.

10. Tighten bolts (2c).
11. Tighten extension 1L (1a) to longitudinal member with screw
12. Tighten extension 3L (1b) to longitudinal member with screw
13. Tighten extension 4L (1c) to longitudinal member with screw (1j).
14. Tighten extension 2L (1d) to longitudinal member with screw and screw (1m).