Remove/Install Lower Engine Compartment Lining - Ar61.20-P-1105LWE

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2023 Mercedes-Benz E63 S AMG, 2023 Mercedes-Benz E53 AMG, 2023 Mercedes-Benz E350, 2022 Mercedes-Benz E53 AMG, and 2022 Mercedes-Benz E350. However, it is still accessible from the selected car via links, so may be relevant.

Model 213

Model 238

MODIFICATION NOTES

13.07.2016

Open engine hood added

Operation step 1

Shown on model 213 with engine 274 except code 481 (underbody protection)

Fig 1: Lower Engine Compartment Lining Component Locations (Model 213 & 238)

Courtesy of MERCEDES-BENZ USA

	Risk of injury from engine start by remote start function	Prior to starting work, open engine hood, do not reach into rotation range or hazard area of freely rotating parts, wear closed and snug- fitting work clothes	AS00.00-Z-0024-01A .
	Remove/install
1	Open engine hood	Vehicles with remote start function
2	Raise vehicle		AR00.60-P-1002LWG .
3	Remove center engine compartment paneling (4)	Model 213, 238 with code 481 (Sump shield) Screw/bolt, underride guard	*BA61.40-P-1001-01D
4	Remove left front engine compartment paneling (1), center front engine compartment paneling (2), right front engine compartment paneling (3) or rear engine compartment paneling (5)	: Push left front engine compartment paneling (1) and right front engine compartment paneling (3) below center front engine compartment paneling (2).
5	Install in the reverse order

UNDERRIDE GUARD (BA61.40-P-1001-01D)

Number	Designation		Model 213 with code 481 (Sump shield)	Model 238 with code 481 (Sump shield)
BA61.40-P-1001-01D	Screw/bolt, underride guard	Nm	17	17