(Remove/Install D-Pillar Trim - AR68.30-P-4497MEX)

Model 167.9 

except code M036 (Maybach version) 

Courtesy of MERCEDES-BENZ USA

Shown on right side of vehicle 

Shown on left side of vehicle 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Fold up seat backrest of third seat row.
2	Remove trims (1).
3	Remove screw/bolts (2).	Screw, seat frame base for 3rd seat row t body	*BA91.12-P-1016-03M
4	Fold up seat cushion (3) and fix in place.
5	Unscrew bolt (4).	Screw, seat belt end fitting/seat belt buckle of 3rd seat row to body	*BA91.40-P-1014-01U
6	Guide out seat belt end fitting (5) with seat belt (6) between load compartment trim (7) and seat towards front.
7	Release load compartment trim (7) in area of D-pillar trim (8).		AR68.30-P-1185MEX
8	Release edge guard (9) in area of D-pillar trim (8).
9	Remove cover (10).
10	Unclip D-pillar trim (8) (arrows) and remove towards rear.	Ensure hook (11) is correctly seated at top in side wall.
		Long wedge	Fig 1
11	Guide seat belt (6) through opening in D-pillar trim (8) and remove D-pillar trim (8).
12	Install in the reverse order.

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA