Remove/Install Line From Cartridge To Inerting System In Engine Compartment - AR86.10-P-0219ME
Model 167 with engine 256
with code 2U8 (Alternative refrigerant)
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove cover of air/water duct. | AR83.10-P-1411ME | |
| 2 | Disconnect the ground line for the on-board electrical system battery (G1). | AR54.10-P-0003ME | |
| 3 | Remove inerting line in engine compartment from cartridge inerting line (1). | AR86.10-P-0119ME | |
| 4 | Remove clamp (3). | Make sure it is correctly locked. |
|
| 5 | Remove screw (2) and take out cartridge inerting line (1). | *BA86.10-P-1004-03B | |
| Check | |||
| 6 | Check cartridge inerting line (1) for damage and flow. | If there is a problem, ↓ Replace cartridge inerting line (1). |
|
| 7 | Install in the reverse order. |
INERTING
| Number | Designation | Model 167 | ||
|---|---|---|---|---|
| BA86.10-P-1004-03B | Screw, gas distributor to partition | M5 | Nm | 4 |