Remove/Install Line From Cartridge To Inerting System In Engine Compartment - AR86.10-P-0219LWE
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2023 Mercedes-Benz GLC43 AMG, 2022 Mercedes-Benz GLC43 AMG, 2021 Mercedes-Benz GLC63 S AMG, 2021 Mercedes-Benz GLC63 AMG, and 2021 Mercedes-Benz GLC43 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 205, 213, 253 with engine 177, 256, 264, 274, 276
with code 2U8 (Alternative refrigerant)
Model 238 with engine 256, 264, 274, 276
with code 2U8 (Alternative refrigerant)
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove rear fender liner in right front fender. | Model 213 with engine 177, 256, 264, 274, 276 with code 2U8 (Alternative refrigerant) Model 238 with engine 256, 264, 274, 276 with code 2U8 (Alternative refrigerant) |
AR88.10-P-1300LWE |
| Model 205, 253 with engine 177, 264, 274, 276 with code 2U8 (Alternative refrigerant) |
AR88.10-P-1300LW | ||
| 2 | Open clamp of piping (1) and remove piping (1) from inerting system cartridge (4). | ||
| 3 | Remove air duct segment with dust filter below the right engine compartment cover. | ||
| Model 213, 253 with engine 177, 256, 264, 274, 276 with code 2U8 (Alternative refrigerant) Model 238 with engine 256, 264, 274, 276 with code 2U8 (Alternative refrigerant) |
AP83.00-P-8381C | ||
| Model 205 with engine 177, 264, 274, 276 with code 2U8 (Alternative refrigerant) |
AP83.00-P-8381B | ||
| 4 | Open clamp (3) and remove piping (1) from distributor. | ||
| 5 | Expose piping (1) and remove. | ||
| Check | |||
| 6 | Check piping (1) for damage and plugging. | If there is a problem, ↓ replace piping (1). |
|
| 7 | Install in the reverse order |