Remove/Install Left Inerting System Line In Engine Compartment - AR86.10-P-0319LWE
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2023 Mercedes-Benz GLC43 AMG, 2022 Mercedes-Benz GLC43 AMG, 2021 Mercedes-Benz GLC63 S AMG, 2021 Mercedes-Benz GLC63 AMG, and 2021 Mercedes-Benz GLC43 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 205, 213, 253 with engine 276
with code 2U8 (Alternative refrigerant)
Model 238 with engine 276
with code 2U8 (Alternative refrigerant)
Shown on engine 276
| Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | ||
| Remove/install | |||
| 1 | Remove left-hand air filter housing | Model 205, 253 with engine 276.8 with code 2U8 (Alternative refrigerant) |
AR09.10-P-1150MMV |
| Model 213, 238 with engine 276.8 with code 2U8 (Alternative refrigerant) |
AR09.10-P-1151MND | ||
| 2 | Unscrew bolt (4) and nut (3) | *BA86.10-P-1002-03E | |
| 3 | Open clamp of pipe (1) and remove pipe (1) from distributor (2) | ||
| 4 | Loosen pipe (1) from retaining clips and remove | ||
| Check | |||
| 5 | Check pipe (1) for damage and plugging | In the event of complaints ↓ Replace pipe (1). |
|
| 6 | Install in the reverse order |
INERTING
| Number | Designation | Model 205 | Model 213 | ||||
|---|---|---|---|---|---|---|---|
| BA86.10-P-1002-03E | Pipe for inerting to engine | M6 | Screw | Nm | 8 | 8 | |
| Nut | Stage 1 | Nm | 8 | 8 | |||
| Stage 2 | ∠° | 30 | 30 | ||||
INERTING
| Number | Designation | Model 238 | Model 253 | ||||
|---|---|---|---|---|---|---|---|
| BA86.10-P-1002-03E | Pipe for inerting to engine | M6 | Screw | Nm | 8 | 8 | |
| Nut | Stage 1 | Nm | 8 | 8 | |||
| Stage 2 | ∠ ° | 30 | 30 | ||||