Remove/Install Inertization Cartridge - AR86.10-P-0106ME
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2025 Mercedes-Benz Maybach GLS600, 2025 Mercedes-Benz GLS63 AMG, 2024 Mercedes-Benz Maybach GLS600, 2024 Mercedes-Benz GLS63 AMG, and 2023 Mercedes-Benz Maybach GLS600. However, it is still accessible from the selected car via links, so may be relevant.
Model 167 with engine 256
with code 2U8 (Alternative refrigerant)
Procedure for removing the cartridge
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove cover of air/water duct. | AR83.10-P-1411ME | |
| 2 | Disconnect the ground line for the on-board electrical system battery (G1). | AR54.10-P-0003ME | |
| 3 | Remove clip (5), remove inerting line (4) from cartridge (1) and place to one side. | ||
| 4 | Release and disconnect electrical connection (3). | Fig 1 | |
| 5 | Unscrew nuts (2). | *BA86.10-P-1001-03B | |
| 6 | Pull cartridge (1) forward and out of bolts (arrow A), guide slightly downward (arrow B), tilt back (arrow C), and remove to the left (arrow D). | ||
| Check | |||
| 7 | Check cartridge (1) and all connections for damage. | If problems occur, ↓ Replace cartridge (1). |
|
| 8 | Install in the reverse order |
INERTING
| Number | Designation | Model 167 | |||
|---|---|---|---|---|---|
| BA86.10-P-1001-03B | Pressure medium reservoir at body | M6 | Screw | Nm | - |
| Nut | Nm | 8 | |||