000 588 05 21 00 Roller Brake Test Stand - WS42.00-P-0006B

Model all (4xWD, BUS, CAR, Light transporter, smart) 

Use in FG 42/43/Set B 

Purpose: 

Car roller brake test stand for checking brake forces at wheels.

Test equipment category CAT_B.

Procurement information: 

This criteria catalog is intended as an aid for selecting one of the commercially available variants of a workshop equipment item. It merely describes the minimum requirements for fulfilling the Mercedes-Benz standard. No reference is therefore made to manufacturer-specific equipment or items.

Courtesy of MERCEDES-BENZ USA

Minimum requirements: 

International technical standard equipment for car brake test stand: 

• Roller set with rideover load of at least 4 t
• Roller set with usable test width of 800 to 2, 200 mm
• Test speed ≥4 km/h
• Engine power approx. 2x4 kW
• Galvanized roller set
• Plastic-coated roller surface with tire-to-road friction coefficient for tire/roller when dry 0.7/wet 0.5
• PC with printer for printing out test log
• Remote control for controlling brake test stand
• Startup blocking protection
• Automatic roller brake for testing automatic vehicles
• Pedal force meter
• Switchover mode from manual to automatic mode
• Automatic on/off circuit and automatic restart
• Standardized data interface for data transfer (e.g. USB, LAN etc.)
• Lockable main switch

Optional: 

• Retractable aid
• Pit safety device for pit installation

Supplement for use with vans: 

• Rollers with rideover load of at least 5 t
• Roller set with usable test width of 800 to 2, 200 mm
• Preinstallation for checking trip recorder and tachographs
• Simultaneous display

Please note the following, depending on the country: 

• While using ASA Life Stream, the use of a second LAN interface is required