Remove/Install Seal For Sliding Roof Panel - AR77.21-P-0560ME
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2025 Mercedes-Benz Maybach GLS600, 2025 Mercedes-Benz GLS63 AMG, 2024 Mercedes-Benz Maybach GLS600, 2024 Mercedes-Benz GLS63 AMG, and 2023 Mercedes-Benz Maybach GLS600. However, it is still accessible from the selected car via links, so may be relevant.
Model 167.1/9
With Code 413 (Automatic panoramic sliding sunroof)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install all-round seal (1) | |||
| 1 | Remove sliding roof panel. | AR77.21-P-0500ME | |
| 2 | Remove all-round seal (1). | Align all-round seal (1), glue on and press on with roller. |
Fig 1 |
| 3 | Remove adhesive residues at panoramic sliding sunroof frame using a surface conditioning disk and clean bonding surface. | ||
| Topical note | Notes on removing adhesive residues and foils on paint and metal surfaces with surface conditioning disks | AH00.00-P-0013-01AK | |
| 4 | Install in the reverse order. | ||
| Remove/install rear seal (7) | |||
| 5 | Remove sliding roof panel. | AR77.21-P-0500ME | |
| 6 | Remove rear seal (7). | Align rear seal (7) and press on with roller. |
Fig 1 |
| 7 | Install in the reverse order. | ||
| Remove/install inner rear seal (5) | |||
| 8 | Remove sliding roof panel. | AR77.21-P-0500ME | |
| 9 | Remove rear inside seal (5). | ||
Align rear inside seal (5), glue on, and press on with roller. |
Fig 1 | ||
| 10 | Remove adhesive residues at panoramic sliding sunroof frame using a surface conditioning disk and clean bonding surface. | ||
| Topical note | Notes on removing adhesive residues and foils on paint and metal surfaces with surface conditioning disks | AH00.00-P-0013-01AK | |
| 11 | Install in the reverse order. | ||
| Remove/install front inside seal (3) | |||
| 12 | Open sliding roof panel. | ||
| 13 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 14 | Remove front inside seal (3). | Handle front inside seal (3) carefully. In order to prevent damage. |
|
| 15 | Check front inside seal (3) for damage. | If damage is detected, ↓ replace front inside seal (3). |
|
| 16 | Install in the reverse order. | ||
| Remove/install front seal (6) | |||
| 17 | Open sliding roof panel. | ||
| 18 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 19 | Remove front seal (6). | Handle front seal (6) carefully In order to prevent damage. |
|
| 20 | Check front seal (6) for damage. | If damage is detected, ↓ Replace front seal (6). |
|
| 21 | Install in the reverse order. |