Remove/Install Roller Sun Blind Guide Rail - AR77.21-P-0231ME

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2025 Mercedes-Benz Maybach GLS600, 2025 Mercedes-Benz GLS63 AMG, 2024 Mercedes-Benz Maybach GLS600, 2024 Mercedes-Benz GLS63 AMG, and 2023 Mercedes-Benz Maybach GLS600. However, it is still accessible from the selected car via links, so may be relevant.

Model 167.1/9

With Code 413 (Automatic panoramic sliding sunroof)

Courtesy of MERCEDES-BENZ USA

	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove
1	Remove roller sunblind drive cables from the panoramic sliding sunroof.		AR77.21-P-0230ME
2	Remove left and right luggage net mounting support (6).	Model 167.1/9 with code 413 (Automatic panoramic sliding sunroof) with code U40 (Safety net for luggage cover) Model 167.1 with code 413 (Automatic panoramic sliding sunroof) with code 541 (Combined luggage cover incl. safety net)
3	Remove rear left and right grab handle mounting support (5).
4	Unclip pipe of the overflow cable (1).	Only on right hand side of vehicle.
5	Secure roller sunblind guide rails (4) against falling down and remove screws (2, 3).	Helper required.
6	Remove roller sunblind guide rails (4).
7	Remove rear left and right covers from the roller sunblind guide rails (4).
	Install
8	Install rear left and right cover on the roller sunblind guide rails (4).
9	Position roller sunblind guide rails (4).	Helper required.
10	Insert a 10 mm drift in the left and right guide (arrows) and tighten screws (2) slightly by hand.	Commercially available devices/tools Drift 10 mm
11	Clip in pipe of the overflow cable (1).	Only on right hand side of vehicle.
12	Insert roller sunblind drive cables flush with the roller sunblind guide rails (4).		AR77.21-P-0230ME
13	Extend roller sunblind drive cables manually, insert roller sunblind on panoramic sliding sunroof and screw roller sunblind to panoramic sliding sunroof tightly.	Tighten screws (2, 3); if the screws of the roller sunblind are tightened, then also install the mounting supports (5, 6).	AR77.21-P-0215ME
		Screw to panoramic sliding sunroof mechanical components	*BA77.21-P-1001-01F
		Screw, mounting support for luggage net to C-pillar	*BA68.30-P-1001-01G

PANELING, TRIM FRAME

Number	Designation		Model 167
BA68.30-P-1001-01G	Screw, mounting support for luggage net to C-pillar	Nm	8

PANORAMIC ROOF

Number	Designation		Model 167 with code 413 (Automatic panoramic sliding sunroof)
BA77.21-P-1001-01F	Screw to panoramic sliding sunroof mechanical components	Nm	7