Prepare Rear Fixed Element Of Panoramic Sliding Sunroof For Installation - AR77.21-P-0802-02ME
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2025 Mercedes-Benz Maybach GLS600, 2025 Mercedes-Benz GLS63 AMG, 2024 Mercedes-Benz Maybach GLS600, 2024 Mercedes-Benz GLS63 AMG, and 2023 Mercedes-Benz Maybach GLS600. However, it is still accessible from the selected car via links, so may be relevant.
Model 167.1/9
With Code 413 (Automatic panoramic sliding sunroof)
| Topical note | Notes on removal/installation of bonded elements of panoramic roof | AH77.21-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A |
- Check rear fixed element (3) for damage.
If damage is present,
↓
replace rear fixed element (3).
- Install cup suction tools to outside of rear panoramic roof and set down rear panoramic roof with inside facing upwards on a suitable base with aid of helper.
Helper required.
- Cut back adhesive bead (1) at rear fixed element (3) using a scraper to a residual height of approx. 1 to
2 mm.
If rear fixed element (3) is reused.
- Fully cut back residues of spacers (4) and adhesive bead (1) present in this area.
If rear fixed element (3) is reused.
- Remove cutting residues using a wet and dry vacuum cleaner.
If rear fixed element (3) is reused.
- Apply cleaner using part of cleaning cloth to bonding surface on inside of rear fixed element (3) and wipe dry with other part of cleaning cloth.
Allow cleaner to dry completely.
- Apply primer uniformly to all bonding surfaces on inside of rear fixed element (3) and allow to fully dry.
Do not apply any primer to uncoated areas.
This primer layer remains visible after installation.
- Replace spacers (4).
If rear fixed element (3) is reused.