Install Front Fixed Element Of Panoramic Sliding Sunroof - AR77.21-P-0803-05ME

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2025 Mercedes-Benz Maybach GLS600, 2025 Mercedes-Benz GLS63 AMG, 2024 Mercedes-Benz Maybach GLS600, 2024 Mercedes-Benz GLS63 AMG, and 2023 Mercedes-Benz Maybach GLS600. However, it is still accessible from the selected car via links, so may be relevant.

Model 167 With Code 413 (Panoramic sliding sunroof/glass roof)

	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Notice	Notes on removal/installation of bonded elements of panoramic roof		AH77.21-P-0001-01A

Only use the repair kit approved by the manufacturer from the replacement part system.

Otherwise, adhesion problems will occur.

Install front stationary element (1) as quickly as possible after the adhesive has been applied to the body.

Otherwise, the front stationary element (1) and the body flange will have adhesion problems.

Courtesy of MERCEDES-BENZ USA

Close panoramic sliding sunroof.
Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
Mount front fixed element (1) on body.
Helper required.

Observe installation position of windshield seal (arrow).
Align front fixed element (1) according to tape strips.
Do not move vehicle for at least 3 h after gluing in front fixed element (1).

The strength of the adhesively bonded connection is otherwise impaired and the required adhesion of the adhesive material is not ensured.
Put loads on front stationary element (1) during curing time of adhesive.
Use flat weights, e. g. sandbags.

Otherwise the front stationary element (1) can be damaged.