Risk Of Injury Caused By Slipping When Clamping Blade In The Multicutter And By Splinters When Cutting Out Bonded Components - AS58.00-Z-0001-01A
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model all (CAR, smart)
Wear cut-proof gloves and safety glasses. Always interrupt air or current supply when changing the cutting blade.
Risk of injury
When inserting or removing the cutting blade of the multicutter (oscillating saw), cut injuries may occur if the tightening wrench slips or if the multicutter is switched on unintentionally.
Injuries to eyes and hands may be caused by flying splinters when cutting out glued-in component parts.
There is a risk of hearing damage when cutting out glued-in component parts with the multicutter.
Safety instructions/precautions
- Always interrupt air or current supply when inserting or removing cutting blade of the multicutter.
- Wear protective gloves.
- Wear safety glasses when cutting out component parts.
- Wear hearing protection.