Prepare Body Flange For Rear Glass Roof For Installation - AR77.21-P-0600-07NKX
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 156
with code 413 (Automatic panoramic sliding sunroof)
Model 205
with code 413 (Automatic panoramic sliding sunroof)
Model 253
with code 413 (Automatic panoramic sliding sunroof)
| Topical note | Notes on removal/installation of bonded elements of panoramic roof | AH77.21-P-0001-01A |
MODIFICATION NOTES
| 10.04.2018 | Notes on removal/installation of bonded panoramic roof elements added. |
Shown on model 156
Shown on model 156
Shown on model 205
- Using a scraper, cut back adhesive bead (1) at body flange to a residual height of approx. 1 to 2 mm.
- Completely cut back residues of spacers (2, 3) and adhesive bead (1) present in this area.
- Remove cutting residues from body flange with wet/dry vacuum cleaner.
- Repair paint damage on body flange.
If required.
- Apply primer in bonding area.
In the case of missing residual adhesive material in bonding area.
- 6.1
Model 156
with code 413 (Automatic panoramic sliding sunroof)
Once primer has dried, glue on new spacers (2) so that flush with body flange edge.
Dimension (A): 200 mm, measured from lower edge at transition of roof frame to body flange.
- 6.2
Model 205, 253
with code 413 (Automatic panoramic sliding sunroof) Once primer has dried, glue on new spacers (2) at center on front and rear body flange.
- 6.1
Model 156